Your cart is currently empty!
Shipping class: Free Shipping
Victron Phoenix Smart IP43 Charger 12/30(1+1) 230V
With boat owners in mind, this adaptive 5-step charger can provide up to 30A of charge to each of three battery banks. Bluetooth enabled, you can monitor the charger and set alarms straight from your phone. Adaptive, intelligent, dynamic charge features.
Phoenix Smart IP43 Charger Features:
Bluetooth Smart enabled
Any Bluetooth enabled smartphone, tablet or other devices can be used to monitor, to change settings and to update the charger when new software features become available.Phoenix Smart (1+1): two outputs to charge 2 battery bank
The second output, limited to approximately 3A and with a slightly lower output voltage, is intended to top up a starter battery.Automatic voltage compensation
The charger compensates for voltage drop over the DC cabling by slightly increasing output voltage when the DC current increases.Adaptive 5-stage charge algorithm: bulk – absorption – recondition – float – storage
The Phoenix Smart Charger features Victron’s well-known ‘adaptive’ battery management system that can be preset to suit different types of batteries. The ‘adaptive’ feature will automatically optimise the charge process relative to the way the battery is being usedThe right amount of charge: variable absorption time
When only shallow discharges occur (a yacht connected to shore power for example) the absorption time is kept short in order to prevent overcharging of the battery. After a deep discharge the absorption time is automatically increased to make sure that the battery will be fully charged.Preventing damage due to excessive gassing: the BatterySafe mode
If, in order to quickly charge a battery, a high charge current in combination with a high absorption voltage has been chosen, the charger will prevent damage due to excessive gassing by automatically limiting the rate of voltage increase once the gassing voltage has been reached.Less maintenance and aging when the battery is not in use: the Storage Mode
The Storage Mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In the Storage Mode float voltage is reduced to minimise gassing and corrosion of the positive plates. Once a week the voltage is raised back to the absorption level to ‘equalize’ the battery. This feature prevents stratification of the electrolyte and sulphation, a major cause of early battery failure.Also charges Li-ion (LiFePO₄) batteries
Charger on-off control can be implemented by connecting a relay or open collector optocoupler output from a Li-ion BMS to the remote on-off port. Alternatively full control of voltage and current can be achieved with Bluetooth.Fully programmable charge algorithm
The charge algorithm can be programmed with help of Bluetooth or the VE.Direct interface. Three preprogrammed algorithms can be selected with the mode button.SKU 3302 Model # PSC123051085 Barcode # 8719076041900 Brand Victron Energy Shipping Weight 4.0000kg Shipping Width 0.275m Shipping Height 0.145m Shipping Length 0.245m Shipping Cubic 0.010500000m3 Victron Phoenix Smart IP43 Charger 12/50(1+1) 230V
SKU 3304 Model # PSC125051085 Barcode # 8719076041627 Brand Victron Energy Shipping Weight 4.0000kg Shipping Width 0.275m Shipping Height 0.145m Shipping Length 0.245m Shipping Cubic 0.010500000m3 Victron Phoenix Smart IP43 Charger 12/50(3) 230V
SKU 3305 Model # PSC125053085 Barcode # 8719076041634 Brand Victron Energy Shipping Weight 4.0000kg Shipping Width 0.275m Shipping Height 0.145m Shipping Length 0.245m Shipping Cubic 0.010500000m3 Victron Blue Smart IP65 Charger 24/5(1) 230V AU/NZ Retail
Victron Blue Smart IP65 Battery Charger
The Blue Smart IP65 Charger is a professional battery charger packed with features such as built-in bluetooth to the Victron Connect App (Available on both iOS and Android). The Blue Smart IP65 Battery Chargers are ideal for use on cars, camper vans, caravans, RV’s, tractors, motorcycles and boats and in the garage or on the farm.
Features:
- Water, dust and chemical resistant
- Seven step smart charge algorithm
- Potential recovery of fully discharged ‘dead’ batteries
- Automatic power supply function
- Severe cold performance: down to -30°C
- Several other battery life enhancing features
- Temperature compensated charging
- Low power mode to charge smaller batteries
- Li-ion battery mode
- Ultra high 95% efficiency “green” battery charger
- Setup and configure, readout of voltage and current by Bluetooth Smart
The battery is charged, smartly and to perfect condition
The seven-step charging algorithm gets the best out of your battery. The charger gives the battery the power it needs, maintains its health, ensures better performance… and a longer life. Victron Blue Smart Chargers also feature a Storage Mode for less corrosion of the positive plates, typically most chargers only offer up to a float mode, the problem is that the lower float charge voltage that follows the absorption period will cause grid corrosion. It is therefore essential to reduce the charge voltage even further when the battery remains connected to the charger during more than 48 hours.
Recovery of deeply-discharged ‘dead’ batteries
Unlike other brands, the Blue Smart IP65 Charger will attempt to recharge a deeply-discharged battery by force-feeding it with a low current. Normal charging will then be resumed as soon as there is sufficient voltage across the battery terminals.
Connect the battery with ease with Quick Fit connection
The charger comes supplied with both alligator clips and M8 eyelets – making it easy to connect to the battery. If you wish, you can leave it permanently connected to your battery. Additional Quick Connects and Accessories are also available to purchase separately.
Check the status of your battery remotely
The Blue Smart IP65 is equipped with built-in Bluetooth, so the status of the charger and the battery can be checked on a smartphone, tablet or laptop. All settings of the charger can be configured with the VictronConnect app. The VictronConnect app allows you to Setup, readout and configure your Blue Smart IP65 Charger via your smartphone (Apple and Android). You can display the status of your charger and battery and even control the functions of your charger using the VictronConnect app. On your screen the readout of voltage and current is default available.
Battery Reconditioning
A lead-acid battery that has been insufficiently charged or has been left discharged during days or weeks will deteriorate due to sulfation. If caught in time, sulfation can sometimes be partially reversed by charging the battery with low current up to a higher voltage.
SKU 3267 Model # BPC240531014R Barcode # 8719076018049 Brand Victron Energy Shipping Weight 1.2300kg Shipping Width 0.300m Shipping Height 0.080m Shipping Length 0.220m Shipping Cubic 0.052800000m3 Victron Blue Smart IP67 Charger 24/5(1)
SKU 3299 Model # BPC240547016 Barcode # 8719076055341 Brand Victron Energy Shipping Weight 2.8000kg Shipping Width 0.250m Shipping Height 0.080m Shipping Length 0.180m Shipping Cubic 0.036000000m3 Victron Blue Smart IP65 Charger 24/8(1) 230V AU/NZ Retail
Victron Blue Smart IP65 Battery Charger
The Blue Smart IP65 Charger is a professional battery charger packed with features such as built-in bluetooth to the Victron Connect App (Available on both iOS and Android). The Blue Smart IP65 Battery Chargers are ideal for use on cars, camper vans, caravans, RV’s, tractors, motorcycles and boats and in the garage or on the farm.
Features:
- Water, dust and chemical resistant
- Seven step smart charge algorithm
- Potential recovery of fully discharged ‘dead’ batteries
- Automatic power supply function
- Severe cold performance: down to -30°C
- Several other battery life enhancing features
- Temperature compensated charging
- Low power mode to charge smaller batteries
- Li-ion battery mode
- Ultra high 95% efficiency “green” battery charger
- Setup and configure, readout of voltage and current by Bluetooth Smart
The battery is charged, smartly and to perfect condition
The seven-step charging algorithm gets the best out of your battery. The charger gives the battery the power it needs, maintains its health, ensures better performance… and a longer life. Victron Blue Smart Chargers also feature a Storage Mode for less corrosion of the positive plates, typically most chargers only offer up to a float mode, the problem is that the lower float charge voltage that follows the absorption period will cause grid corrosion. It is therefore essential to reduce the charge voltage even further when the battery remains connected to the charger during more than 48 hours.
Recovery of deeply-discharged ‘dead’ batteries
Unlike other brands, the Blue Smart IP65 Charger will attempt to recharge a deeply-discharged battery by force-feeding it with a low current. Normal charging will then be resumed as soon as there is sufficient voltage across the battery terminals.
Connect the battery with ease with Quick Fit connection
The charger comes supplied with both alligator clips and M8 eyelets – making it easy to connect to the battery. If you wish, you can leave it permanently connected to your battery. Additional Quick Connects and Accessories are also available to purchase separately.
Check the status of your battery remotely
The Blue Smart IP65 is equipped with built-in Bluetooth, so the status of the charger and the battery can be checked on a smartphone, tablet or laptop. All settings of the charger can be configured with the VictronConnect app. The VictronConnect app allows you to Setup, readout and configure your Blue Smart IP65 Charger via your smartphone (Apple and Android). You can display the status of your charger and battery and even control the functions of your charger using the VictronConnect app. On your screen the readout of voltage and current is default available.
Battery Reconditioning
A lead-acid battery that has been insufficiently charged or has been left discharged during days or weeks will deteriorate due to sulfation. If caught in time, sulfation can sometimes be partially reversed by charging the battery with low current up to a higher voltage.
SKU 3268 Model # BPC240831014R Barcode # 8719076018087 Brand Victron Energy Shipping Weight 1.2300kg Shipping Width 0.300m Shipping Height 0.080m Shipping Length 0.220m Shipping Cubic 0.052800000m3 Victron Blue Smart IP22 Charger 24/12(1)
style:none} }
Specifications
Victron Blue Smart IP67 Charger 24/12(1) 230V AU/NZ
SKU 3301 Model # BPC241247016 Barcode # 8719076052456 Brand Victron Energy Shipping Weight 2.8000kg Shipping Width 0.250m Shipping Height 0.080m Shipping Length 0.180m Shipping Cubic 0.036000000m3 Victron Blue Smart IP65 Charger 24/13(1) 230V AU/NZ
Victron Blue Smart IP65 Battery Charger
The Blue Smart IP65 Charger is a professional battery charger packed with features such as built-in bluetooth to the Victron Connect App (Available on both iOS and Android). The Blue Smart IP65 Battery Chargers are ideal for use on cars, camper vans, caravans, RV’s, tractors, motorcycles and boats and in the garage or on the farm.
Features:
- Water, dust and chemical resistant
- Seven step smart charge algorithm
- Potential recovery of fully discharged ‘dead’ batteries
- Automatic power supply function
- Severe cold performance: down to -30°C
- Several other battery life enhancing features
- Temperature compensated charging
- Low power mode to charge smaller batteries
- Li-ion battery mode
- Ultra high 95% efficiency “green” battery charger
- Setup and configure, readout of voltage and current by Bluetooth Smart
The battery is charged, smartly and to perfect condition
The seven-step charging algorithm gets the best out of your battery. The charger gives the battery the power it needs, maintains its health, ensures better performance… and a longer life. Victron Blue Smart Chargers also feature a Storage Mode for less corrosion of the positive plates, typically most chargers only offer up to a float mode, the problem is that the lower float charge voltage that follows the absorption period will cause grid corrosion. It is therefore essential to reduce the charge voltage even further when the battery remains connected to the charger during more than 48 hours.
Recovery of deeply-discharged ‘dead’ batteries
Unlike other brands, the Blue Smart IP65 Charger will attempt to recharge a deeply-discharged battery by force-feeding it with a low current. Normal charging will then be resumed as soon as there is sufficient voltage across the battery terminals.
Connect the battery with ease with Quick Fit connection
The charger comes supplied with both alligator clips and M8 eyelets – making it easy to connect to the battery. If you wish, you can leave it permanently connected to your battery. Additional Quick Connects and Accessories are also available to purchase separately.
Check the status of your battery remotely
The Blue Smart IP65 is equipped with built-in Bluetooth, so the status of the charger and the battery can be checked on a smartphone, tablet or laptop. All settings of the charger can be configured with the VictronConnect app. The VictronConnect app allows you to Setup, readout and configure your Blue Smart IP65 Charger via your smartphone (Apple and Android). You can display the status of your charger and battery and even control the functions of your charger using the VictronConnect app. On your screen the readout of voltage and current is default available.
Battery Reconditioning
A lead-acid battery that has been insufficiently charged or has been left discharged during days or weeks will deteriorate due to sulfation. If caught in time, sulfation can sometimes be partially reversed by charging the battery with low current up to a higher voltage.
SKU 3269 Model # BPC241331014 Barcode # 8719076051572 Brand Victron Energy Shipping Weight 2.2000kg Shipping Width 0.400m Shipping Height 0.090m Shipping Length 0.185m Shipping Cubic 0.068400000m3 Victron Phoenix Smart IP43 Charger 24/16(1+1) 230V
SKU 3306 Model # PSC241651085 Barcode # 8719076041924 Brand Victron Energy Shipping Weight 4.0000kg Shipping Width 0.275m Shipping Height 0.145m Shipping Length 0.245m Shipping Cubic 0.010500000m3 Victron Phoenix Smart IP43 Charger 24/25(1+1) 230V
SKU 3308 Model # PSC242551085 Barcode # 8719076041641 Brand Victron Energy Shipping Weight 4.0000kg Shipping Width 0.275m Shipping Height 0.145m Shipping Length 0.245m Shipping Cubic 0.010500000m3 Victron Skylla-TG 48/25(1) 230V
SKU 3342 Model # SDTG4800251 Barcode # 8719076025801 Brand Victron Energy Shipping Weight 6.7000kg Shipping Width 0.320m Shipping Height 0.450m Shipping Length 0.240m Shipping Cubic 0.034560000m3